This article will cover how to assemble the handles on your cordless lawnmower.


TABLE OF CONTENTS


The procedure for assembling the handles depends on the model type, however, the mechanism is similar across the models.


Upper Handles:

The most common issue is with the 'quick-release clamps' half-way down your handles, where the upper handles connect with the lower handles. As long as you have got the parts assembled in the correct order, it should not be a problem:


EXAMPLE from the S1637ER electric mower - the same mechanism applies for all lawnmowers with the 'quick release clamps'


  1. Ensure that you insert the bolt from the inside of the handles, so that the head of the bolt is on the inside - as circled in red above.
  2. Ensure that you have placed a washer on the outside of the handles, so that the washer is flush against the outside - as circled in green above.
  3. Then, you screw the 'quick release clamp' lever onto the bolt thread.
  4. Screw it until you have the desired tightness - then press down on the lever, as indicated above as '1' and '2'.


Please attempt this procedure as closely and carefully as possible. You should find that the bolt provided is long enough. However, if you have tried this to the best of your abilities and the bolt is still not sufficient in length, then please contact our technical helpline.


Connecting Lower Handles to the Mower

Another common issue is being unable to secure the lower handle parts to the lawnmower. Again, this varies depending on the model. If it is meant to slot in place and be fixed by screws, make sure that the handle is fully inserted. Note: This may require some force.